Specifications of the Albatross

The Albatross is said to be able to run at speeds up to 120 MPH; this not to say how fast the craft could travel with a good wind at her back. Other specifications of the Albatross are directly from Verne’s Rubur the Conqueror.

“Platform—This was a framework a hundred feet long and twelve wide, a ship's deck in fact, with a projecting prow. Beneath was a hull solidly built, enclosing the engines, stores, and provisions of all sorts, including the water tanks. Round the deck a few light uprights supported a wire trellis that did duty for bulwarks. On the deck were three houses, whose compartments were used as cabins for the crew, or as machine rooms. In the center house was the machine which drove the suspensory helices, in that forward was the machine that drove the bow screw, in that aft was the machine that drove the stern screw. In the bow were the cook's galley and the crew's quarters; in the stern were several cabins, including that of the engineer, the saloon, and above them all a glass house in which stood the helmsman, who steered the vessel by means of a powerful rudder. All these cabins were lighted by port-holes filled with toughened glass, which has ten times the resistance of ordinary glass. Beneath the hull was a system of flexible springs to ease off the concussion when it became advisable to land.

Engines of Suspension and Propulsion—Above the deck rose thirty-seven vertical axes, fifteen along each side, and seven, more elevated, in the center. The "Albatross" might be called a clipper with thirty-seven masts. But these masts instead of sails bore each two horizontal screws, not very large in spread or diameter, but driven at prodigious speed. Each of these axes had its own movement independent of the rest, and each alternate one spun round in a different direction from the others, so as to avoid any tendency to gyration. Hence the screws as they rose on the vertical column of air retained their equilibrium by their horizontal resistance. Consequently the apparatus was furnished with seventy-four suspensory screws, whose three branches were connected by a metallic circle which economized their motive force. In front and behind, mounted on horizontal axes, were two propelling screws, each with four arms. These screws were of much larger diameter than the suspensory ones, but could be worked at quite their speed. In fact, the vessel combined the systems of Cossus, La Landelle, and Ponton d'Amécourt, as perfected by Robur. But it was in the choice and application of his motive force that he could claim to be an inventor.

Machinery—Robur had not availed himself of the vapor of water or other liquids, nor compressed air and other mechanical motion. He employed electricity, that agent which one day will be the soul of the industrial world. But he required no electro-motor to produce it. All he trusted to was piles and accumulators. What were the elements of these piles, and what were the acids he used, Robur only knew. And the construction of the accumulators was kept equally secret. Of what were their positive and negative plates? None can say. The engineer took good care—and not unreasonably—to keep his secret unpatented. One thing was unmistakable, and that was that the piles were of extraordinary strength; and the accumulators left those of Faure-Sellon-Volckmar very far behind in yielding currents whose ampères ran into figures up to then unknown. Thus there was obtained a power to drive the screws and communicate a suspending and propelling force in excess of all his requirements under any circumstances.”

Rubur the Conquerer, Chapter 7 On Board The Albatross, Jules Verne